ABS Antis Handle Mini Static Grass Flocking Applicator with 4 Grass Powders for DIY Modelling

inside the handle is with low power dissipation and high voltage output, makes this flocking machine quite b flocking ty. Specially design for flocking in small area, sand table construction model, and other DIY scenes. You can have a try.



Using Steps:

Charge the battery before using and check if the wire inside the machine is in with the wire mesh.

Put in the grasspowder.

It has been suggested that the length of the grasspowder is more than 5 mm, which is more effective.

Then tighten the lid.

On the target model and on the table, pull out the whitelatex and spread it evenly, ready to starts dusting with grasspowder.

Touch the target surface of the platform with the electrical connector as close as possible, then use the seeder grass to starts spraying the grasspowder 20-30mm away from the platform target.

After the grass is completed, pour the grasspowder or powder-supplement and blot it with a vacuum cleaner model.

Cut the haystack with small-scissors and a toothpick until it grows evenly.

Note:

Do not use the terminal to them with the wire mesh, there is a danger caused by sparks!

Use limit of less than 16 years old!

Remove the battery and place it high when not in use.

Static grass applicator is suitable for 3-5mm staticgrass.

Powered by 2* AA battery, you should prepare it by yourself.



Specifications:

Name: Static Grass Flocking Applicator Set

Material: ABS

Battery: 2* AA battery (excluded)

Rated working voltage: DC3V

Rated working power: 0.15W

Rated output voltage: ≥DC3000V

Rated working t: 50mA

Package size: 320* 120* 120mm/ 12.60* 4.72* 4.72in

Package weight: 365g/ 12.87ounce



Packing List:

1* Brush

4* Bags of Static Grass

1* Static Grass Applicator

1* Guideline