Bambu Lab PLA Matte Filament Refill Pack Without Spool - Terracotta 1kg - 1.75mm

Bambu Lab PLA Matte Filament Refill Pack Without Spool – Terracotta 1kg – 1.75mm – High Speed – Smooth – Soft Texture – 11203

Downloads: Filaments TDS
Bambu Lab PLA Matte – Terracotta
- Easy to Print & Beginner Friendly
- Matte Surface Texture
- Biodegradable
- Diameter: 1.75mm +/- 0.03mm
Cautions for Use
AMS & AMS lite Compatible




Accessory Compatibility

PLA Matte Hex Code Table

RFID for Intelligent Printing
All printing parameters are embedded in RFID, which can be read through our AMS (Automatic Material System).
Load and print! No more tedious setting steps.


Printing Tips
Drying conditions: 55°C for 8 hrs. Store in a dry environment after use. Dry before use if the material absorbs moisture. For more details please refer to: Filament drying instructions on WIKI.

Recommended Printing Settings
Drying Settings (Blast Drying Oven)
50 °C,8 h
Printing and Keeping Container’s Humidity
< 20% RH (Sealed, with Desiccant)
Nozzle Temperature
190 – 230 °C
Bed Temperature (with Glue)
35 – 45 °C
Printing Speed
< 300 mm/s
Physical Properties
Density
1.31 g/cm³
Vicat Softening Temperature
63 °C
Heat Deflection Temperature
58 °C
Melting Temperature
163 °C
Melt Index
39.4 ± 3.2 g/10 min
Mechanical Properties
Tensile Strength
30 ± 5 MPa
Breaking Elongation Rate
14.8 ± 4.2 %
Bending Modulus
2360 ± 250 MPa
Bending Strength
53 ± 6 MPa
Impact Strength
19.2 ± 3.7 kJ/m²

Please note that this item is located outside Australia. Product complies with Australian standards.