Motogadget mo.unit basic

The mo.unit basic is an improvement on the mo.unit v2, now featuring 12 inputs, 10 outputs and interchangeable quality cable clamps. It offers the same advantages as the mo.unit blue, but without the Bluetooth® LE and connection to the mo.ride app. 

The mo.unit basic is the digital control unit for your motorcycle – the heart of the entire on-board electrical system. It can be operated using buttons, conventional handlebar switches, or smartphone App, and it controls all necessary components on the bike, while also performing fuse functions.

• Complete digital control using buttons, with 4 or 5-button operation. Operation with switch also possible.
• Complete replacement for the fuse box. 10 independent circuits are digitally monitored and switched off if there are faults. After the fault is rectified, the backup function is automatically reset.
• Integrated alarm system that can be installed in any position.
• Integrated, digital flasher relay that is load-independent; automatic switch-off optional and can be set; mo.wave mode can be selected.
• Integrated hazard warning light - also works when ignition is off.
• Turn signal can optionally be set as a positioning light.
• Integrated parking light and headlight flashing.
• Lo-beam and Hi-beam (up to 200 W switched capacity) can be controlled using only one button.
• Integrated, digital brake light modulator; flashing mode can be programmed.
• Acceleration-controlled emergency brake light (automatic warning signal).
• Integrated starter relay for the starter system with solenoid (up to 30 A switched capacity).
• Intelligent and configurable management/switch-off of power consuming devices so that the maximum starting energy from the battery can be used when starting the motorbike.
• Integrated, digital horn relay.
• Two configurable additional outputs AUX1 and AUX2.
• Diagnostics function for assigning inputs, outputs, the circuit switching status, short circuit diagnostics etc.
• Calibration and current measurement enables faults to be detected on all lamps.
• Waterproof and vibration resistant

• mo.unit basic
• 1 x M5 stainless steel bolt
• 2 x M5 stainless steel bolts with nut
• Detailed installation and operating instructions

• L/W/H: 90 x 53 x 30 mm, bolt distance 74 mm
• Weight: Approx. 180 g
• Fastener: 2 x M5 stainless steel bolts (installation and ground connection), 1 x M5 screwing contact for battery Plus
• Operating voltage: 6 V - 20 V
• Operating temperature: -20°... +80°C
• Inputs: 
  - 1 x input (+12 V switched) for ignition lock or m.lock
  - 11 x control input (minus/switched to ground) for:
  Left turn signal
  Right turn signal
  Lo/Hi-beam
  Starter
  Horn
  Brake light
  Kill switch
  Stand switch
  LIN bus
  AUX1
  AUX2
• Outputs: 
  - 10 x Outputs (+12V) for:
  Left turn signal
  Right turn signal
  Lo-beam
  Hi-beam
  Starter
  Horn
  Brake light
  Ignition
  AUX1
  AUX2