Z Axis Tool Automatic Tool Sensor Gauge For CNC Router Engraving​ Machine Setter

About this item:

• Description: The tool setting instrument is a special tool setting instrument for the engraving machine machining center machine. The output signal of the tool setting instrument is received by the numerical control system and then the tool length setting, tool wear detection and tool breakage are detected by the program control. In the case of no vibration and malfunction, the thermal deformation of the machine can be corrected according to the rated voltage and current and the specified speed.
• Material: The housing material of this tool setter is made of 4S grinding grade material. The bottom magnet design can be directly connected to the machine and firmly adsorbed to the body. The contact material is made of super hard alloy, the design is exquisite and the installation is simple.
• Feature-1: This tool setting instrument is designed with dustproof and waterproof structure, which can still have strong durability under the condition of coolant and iron filings. It does not need a built-in amplifier and will not be caused deviations by the location temperature and power supply voltage fluctuations of the tool setting instrument, which can be directly input to the NC program.
• Feature-2: The tool setter will send out an alarm signal in time when it is over-travel to avoid other troubles caused by equipment operation. Moreover, the tool setter has strong anti-interference. The protruding sharp corner of the tool directly touches the tool tip related to the machining size, detects its value and size, and outputs the signal. It has higher accuracy than the average value obtained by converting the amount of light and electricity.

• It can greatly improve the efficiency of tool setting in CNC machining.
• It will alert when the stroke is exceeded.
• Automatic detection of tool breakage: If the tool is damaged or broken, the machine automatically stops running and warns.
• Automatic tool wear compensation: Once the head wear is detected, the relevant program can be corrected to ensure the accuracy of the workpiece.

• 1 x SET

1. The props and the tool setting device must be perpendicular to the contact surface, and vertically contact the contact surface, please install as much as possible on the workbench where the iron filing area is small.
2. Be sure to use the voltage within the rated power supply range, please control the DC10-30V, the current is below 20mA, the ambient temperature range is -25° C-70° C.
3. Please control the cutter tool diameter below 20mm and the cutter speed to be below 50-200mm/min. The tool center should fall to the center of the tool face.