LED TRAILER LIGHTS KIT TAIL STOP INDICATORS LAMPS NUMBER PLATE & WIRING DB22LP

DB2 TAILAMP SPECIFICATIONS
Low Profile ADR approved IP67 100% Water proof
Voltage: 12V
Dimensions: 150mm x 50mm x 25mm  (see below )
Mounting: Surface mount onto flat surface vertically with Indicator at top or horizontally with indicator facing out using prefitted genuine 3m tape and plug through 10mm hole on mounting surface .

NUMBER PLATE LIGHT SPECIFICATIONS
Low Profile ADR approved IP67 100% Water proof
Voltage: 12 Volt
Warranty: 5 Years
Dimensions: 60mm x 33mm x 22mm
Mounting: Surface mount onto flat surface using prefitted genuine 3m tape and plug through 10mm hole on mounting surface .

LIGHT MOUNTING TIPS
For best results from 3M™ Tapes the surfaces should be clean and dry, and provide adequate pressure for ensuring a permanent bond with the surface. Also, ensure the application temperature is sufficient to build adhesion. 3M™ Tapes will build adhesion with time.
Clean :Before applying 3M™ Tapes ensure the surfaces are cleaned with a mixture of soapy water. Exceptions to the general procedure, which may require additional surface preparation include:Heavy Oils where
A degreaser or solvent-based cleaner is required to remove heavy oil or grease from the surface. Note here that this process should begin only after cleaning with the mixture of soap and water.
Abrasion This process should begin only after cleaning the surface with the soap and water mixture – abrasing a surface can remove heavy dirt or oxidation and increases surface area to improve adhesion.
The ideal temperature for application is between 70ºF to 100ºF (21ºC to 38ºC).Note:here that the initial tape application to surfaces at temperatures below the suggested minimum temperatures is not recommended, because the adhesive becomes too firm. However, if the tape is applied properly, the low temperature bonding is generally satisfactory. To obtain the best performance with all 3M™ VHB™ Tapes, ensure that the surfaces are dry and free of condensed moisture.After application, the bond strength increases, as the adhesive flows onto the surface. At room temperature, the adhesion becomes stronger – 50% (approx.) after 20 minutes, 90% after 24 hours and 100% after 72 hours.

CONNECTION FOR 5 PIN
2  left hand turn -  yellow
3  earth  -  white                            
5  right hand turn -  green
6  stop  -  red
7  tail, clearance, side markers  -  brown

CONNECTION FOR 7 PIN
1  left hand turn -  yellow     
2  reverse  -  black                                         
3  earth  -  white                                                                            
4   right hand turn -  green                                        
5  electric brakes  -  blue
6  stop  -  red
7  tail, clearance, side markers  -  brown

CONNECTION FOR 6 PIN
1  tail, clearance  -  brown                                  
2  left hand turn  -  yellow 
3  right hand turn -  green
4  stop -  red
5  electric brakes  -  blue
6  earth  -  white